LC5, LC20 and 705ss reel seat inserts
Polished hardwood, cork, carbon and acrylic inserts to match Lemke Concepts LC5, LC20 and 705ss reel seats, to fit both up lock or down lock seats.
One insert can be purchased for each set of reel seat hardware at the price listed. The surcharge price applies for any inserts purchased without matching hardware.
Customers outside the UK: export purchase price will apply excluding UK VAT sales tax
Inserts labelled with a two or three letter code are hand made by Taniwha Rodworks and each is unique (one of each). If several inserts are listed as available under one code, then they are all very similar in appearance, colour, figure and quality to the one pictured.
Where the code has a third letter 'S' the wood has been stabilised by infusion with acrylic resin under vacuum and/or pressure. These inserts are hand made in the UK by Taniwha Rodworks using a range of techniques and finishes to enhance wood figure and grain finishing with at least three dip coats of ultra hard, waterportoof and flexible UV resistant clear coat. Then polished to a high gloss finish.
Lower cost wood and cork inserts without individual 2 or 3 letter codes are made for us and are not stablised. For these wood inserts the photo provided is representative and the ones in the phote are likely to be already sold. You will receive one in the same wood burl and colour, but each will have their own unique colour and grain pattern.
LC5 and LC20 inserts
Outer diameter 0.705" 17.9mm
Length of polished section 2.4" 60mm approximately
Diameter of rebate for screw fiitting (maximum) 0.64" 16.3mm
Length of rebate for screw fiitting 0.75-1.25" 20-30mm
Internal bore 0.45" 12mm approximately
Insert weight typically 9-10g