Carbon fibre full wells 7" 180mm fly rod grip with an optional 35mm 1.3" fighting butt
Inlet 22mm for uplocking reel seats and bored 9-9.5mm.
Fits our reel seats SUL2, LC5, LC20, UL5, UL6, UL8
Reverse half wells grip listed separately will fit smaller reel seats and slimmer blanks
Woven carbon fabric over urethane foam core. An interesting alternative to cork that is comfortable to hold with good grip, and as light as cork. Easy to ream if required to fit your blank, if you are buying a blank from us we will do this for you (but not otherwise).
The handle can be used 'as is' or coated 'smooth' with epoxy guide finish or a similar flexible clear finish e.g. urethane varnish. Dry on a rod turner.
The listing price is for the handle only. The reel seats shown can be purchased separately.
Blanks of less than 9mm butt diameter may be fitted wth a gap filling gel epoxy or polyurethane glue. If the grip is a bit loose apply a few turns of thin width masking tape near each end to help centre the grip on the blank. ,
Length 178mm (7")
Diameter at central flare 26.5mm / approx 1.05"
Maximum reel seat hood diameter 22.5mm, difficult to enlarge any further